I follow a lot of reddit subgroups which showcase network racks and I was tired of my setup where all the switches were all over the place and not organised.
So I did some research and purchased a kitchen bridging unit and rewired my whole set up.

Related: Never again let it all out. Make a discreet network cabinet.
The only unknown was how I was going to stack my switches until I remembered that we had a spare NYPLOCKAD that I can repurpose with a minor tweak.
IKEA items used:
- NYPLOCKAD plate holder, beech (Similar to OSTBIT)

Photo: IKEA.com
Other materials and tools:
- MDF 12mm + 2x screws
DIY network rack setup:
Screw a couple of pilot holes into each end and affix the MDF sheet so it stands upright.

I had the spare MDF piece lying around so no cost and £3 for the plate stand.

All in all, pretty pleased with DIY network rack.
~ by Sunil Chauhan
The post Plate holder completes this DIY network rack appeared first on IKEA Hackers.
Comments
Post a Comment